SLIDE GATE OPERATOR 

  SWING GATE OPERATOR 

 
  • Coded radio remote control in vehicle-100 metres range

  • Indoor remote control installed inside your house

  • Auto-open feature

  • Auto close timer

  • Instant reversal using infrared sensors

  • Obstacle sensing mechanism

  • Soft start/stop in open and close travel motions

  • Automatic calling bell, gate lamp and intercom

  • Five Lock modes

  • Vehicle and pedestrian mode

  • Maximum run timer

  • Manual closing function (Electronic and Mechanical)

  • Intruder alarm

  • Gate panel switches for vehicular and pedestrian use

  • Built in battery backup with charge controller

  • Micro computer based design

  • Warning Lamp

  • Reversible gate direction

  • Manual lock release lever

  • LED diagnostic centre for easy trouble shooting

  • Error display on indoor unit for trouble shooting

  • MOSFET motor drive

  • Twilight switch for gate lamp

  • High torque 1/6 hp 24 volts DC motor

  • All rust proof construction

  • Direct drive gear

 
 
 
 
   

INDOOR REMOTE CONTROLLER

     

LOCK MODES AND MANUAL OPERATION

 

 

This remote control is installed inside your house.

  • Position and movement of gate, status of infra red sensors etc. are displayed

  • Pedestrian button for partial and Vehicle button for full opening

  • Lock changing buttons

  • Gate lamp switch

  • Calling bell enable/disable button

  • Intercom disable/enable button

  • Child lock

 

 

Equipped with five different lock modes for user convenience.

  • Mode5: Auto-open feature, gate switches, radio remote controller and indoor remote controller are unlocked.

  • Mode4: Auto-open feature is restricted

  • Mode3: Auto-open feature and gate switches are disabled.

  • Mode2: Only the indoor remote controller is unlocked.

  • Mode1: Fully locked

Child Lock: This feature prevents the access of lock changing switches from children and unauthorized persons.

Manual closing function: In case, the gate is not closed and showing some error message, manual closing of gate can be done from indoor remote controller.

 

   

CODED REMOTE CONTROLLER

     

GATE PANEL SWITCH

 

 

You can open and close gate from your vehicle. You don't have to get out into rain to open your gate.

  • Open and close Button

  • Range is about 100metres-line of sight

 

 
  • Pedestrian and vehicle switch

  • Illumination LEDs
     

 

   

INFRARED BARRIERS

     

WALL MOUNTED INFRARED BARRIERS

 

 

Instant reversal using IR sensors: Interruption of any infrared sensor beams while gate is closing reopens the gate.

Auto-open feature: Infrared sensors 3 & 4 are provided for automatic opening of the gate. When beam of infrared sensor-3 is interrupted, gate will open 1/3 of its travel for pedestrian. If sensor3 & 4 are interrupted together then gate opens fully for vehicles.
 

 

 

Automatic calling bell and intercom feature: When some one comes in front of the gate and interrupts infrared sensor-1, the calling bell will ring. Meantime CCTV/intercom unit, gate lamp are also turns on. After 30 seconds, the power to gate lamp, intercom /CCTV  are switched off if the gate is in closed position. Otherwise stays on.
 

 

   

MOTOR AND OBSTACLE SENSING MECHANISM

     

LOCK RELEASE MECHANISM

 

 

 
  • 1/6 hp 24 volts permanent magnet DC motor

  • Direct drive gear

  • Obstacle sensing mechanism

  • Gate lock (Slide gate)

  • Reference pulse generator

  • Manual release lever

  • Manual lock release (Slide gate)

Obstacle sensing mechanism: Automato gate operator has an exceptionally safety feature, when it is adjusted properly, it delivers just adequate power to the motor to overcome the resistance of gate. Upon sensing an obstacle on path, gate moves backwards and retries ten times to close/open, then halts. These retrials may help to clear the obstacle away.
 

Reversible gate direction : For right or left handed operation of sliding gate.
 

 

 

 

Manual release lever: Upon complete system failure (lightning, surges, etc...)gate can be pushed open/close by hand. For slide gate a simple push-pull lever is built into front side of the operator. By pulling and turning this lever gate can be released from driving mechanism. For swing gate keys are provided to unlock the motor and lock.


Manual lock release: Upon complete system failure gate can be unlocked by pushing this lever manually.
 

 

   

RADIO RECEIVER AND WARNING LAMP

     

BATTERY CHARGE CONTROLLER

 

 

 
  • Antenna for coded radio receiver

  • LED indicator for data reception

  • Bright warning lamp

Warning lamp : Warning Lamp will flash when the gate is closing or opening.
 

 

 

When the level of charge reaches full, charging of battery is stopped. When the level of charge reaches below low level, power supply output to all the units are switched off to prevent the battery drain. When power is restored output is also restored.

  • Battery low cut-off

  • Prevents over/under charge

  • Charging indicator

  • Battery low/high indicator

  • Battery fuse and on/off switch
     

 

   

PROCESSING UNIT

     

LED DIAGNOSE CENTRE AND RESET SWITCH

 

 

Auto Close timer: This feature will close the gate automatically after a specific amount of time has elapsed. For pedestrian use amount of time is 4 seconds, and for vehicular use it is 60 seconds.

Soft start/stop in open and close travel motions: This unique feature of Automato will begin opening/ closing gate very slowly and will gradually increase to full speed. Then gradually decreases speed before stopping. This creates a very gentle gate translation which considerably reduces the amount of wear and tear on all mechanical parts.
Intruder alarm: When in locked mode(1,2&3), if someone tries to tamper gate lock and open gate by force, the intruder alarm function is activated.
Vehicle and pedestrian mode: Partial opening of gate for pedestrians use and full opening of gate for vehicle are implemented.
Maximum Run Timer of five minutes for motor in both directions.

 

 

 

 

LED diagnostic centre: Implemented for easy on-site trouble shooting. These LEDs help to simplify installation and troubleshooting for installer and user.

 

   

POWER SUPPLY AND TWILIGHT SWITCH

     

BUILT-IN BATTERY BACKUP

 

 

Twilight switch for gate lamp: Twilight switch is provided to switch on gate lamp at dusk and switch off at dawn automatically.
 

 

  Built in battery backup: Inherent 24 VDC backup power with  two/four  12V-7Ah batteries.     Main and most obvious benefit to having battery back-up is the ability to open and close gate even when there is no power. If there is a power failure gate will operate as it normally does and can be opened up to 150 times before power is restored.
 
 


|   Home   |   Products   |   Demo   |   Contact   |

  2005-2020 Automato Access Controls Private Limited

www.automato.in